This is where we complete the Jerk. The mask is filled with expanding foam.
The head is attached to the body with all the finishing touches.
We might even take him out for a test ride.
These holes have been taped up to prevent foam from leaking out.
Insert rod for hanging mask.
Correct placement of rod.
Hang mask in 5 gallon bucket.
Spray foam in thin layers.
Allow each layer to expand.
Incert PVC pipe used to attach head to body.
This head is finnished and ready to attach to the body.
A cable is attached to inner PVC frame.
An electrical cord is plugged into the Jerk.
A hole is drilled through the top board of the gallows.
The cable is attached to the eyebolt.
The cable holds all of the weight, not the rope.
Slip the noose around the neck and tie it off.
Wrap twine around the rope, wire and cable.
I'm pretty sure he is dead.
This is how we tied off our noose.
This is one way to hide the motion sensor. We chose to mount it on top of the gallows.
Just hangin with the Jerk.
